L300/L230/L130 User Manual4Safety InformationRefer to the following to prevent any physical injury or loss of assets caused by damage to the product.A user must read this User Manual carefully before use and properly follow the instructions. Make sure that the place of installation is not too hot (above 35˚C), too cold (below 0˚C), or too wet(above 85% relative humidity). Avoid any severe impacts to the product Make sure that the product is not exposed to direct sunlight or any hot machinery. Please keep the product away from any items which have strong magnetic properties. Do not disassemble, repair or rebuild the product. Please properly route all cables and power cords to avoid a tripping hazard. An electric shock, fire,damage to the product or physical injury may occur as a result of tripping over the cable.Regulatory ComplianceFCC InformationThis equipment has been tested and found to comply with the limits for a class B digital device, pursuant topart 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed andused in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined by turning the equipment off andon, the user is encouraged to try and correct the interference by one or the following measures: Reorient or relocate the receiving antenna Increase the separation between the equipment and the receiver Connect the equipment to a power outlet on a circuit different from which the receiver isconnected Consult your dealer or an experienced radio TV technician for helpChanges or modifications not expressly approved by the party responsible for compliance could void the user’sauthority to operate the equipment.This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, includinginterference that may cause undesired operation.