NEC 60XM5 - PlasmaSync - 60" Plasma Panel User Manual

Also see for 42XM5 - PlasmaSync - 42" Plasma Panel: Supplementary guide Supplementary guide User manual Brochure & specs Installation guide

NEC 60XM5 - PlasmaSync - 60" Plasma Panel User Manual Manual pdf 8 page image

En-7IN OUT4 REMOTEEXTERNAL CONTROLRemote ControlCable*To Remote JackApprox.7 m/23 ftMENU/ENTERINPUT SELECTDOWN UP LEFT/ - RIGHT/+ /EXITVOLUMEMENU/ENTERINPUT SELECTDOWN UP LEFT/ - RIGHT/+ /EXITVOLUMETop sideBottom side90°: RGB: RGB: AUTO: 1080B: OFF: OFF1024768EXITSEL.RETURNMENU/ENTER OKOPTION1OSMBNC INPUTD-SUB INPUTRGB SELECTHD SELECTINPUT SKIPALL RESETUsing the remote controlBattery Installation and ReplacementDesignated batteries:Please use size AAA (R03) or AAA (LR03).Insert the 2 “AAA” batteries, making sure to set them inwith the proper polarity.1.Press and open the cover.2.Align the batteries according to the andindication inside the case.3.Replace the cover.* The 1/8 Stereo Mini cable must be purchased separately.Operating Range* Use the remote control within a distance of about 7 m/ 23ft. from the front of the monitor’s remote control sensorand at horizontal and vertical angles of up to approximately30°.* The remote control operation may not function if themonitor’s remote control sensor is exposed to directsunlight or strong artificial light, or if there is an obstaclebetween the sensor and the remote control.Using the wired remote control modeConnect the remote cable* to the remote control’s remotejack and the “REMOTE IN” terminal on the monitor.When the cable is connected, the mode automaticallyswitches to wired remote control. When the wired remotecontrol mode is used, the remote control can be operatedeven if no batteries are loaded.CAUTION• Use only the specified batteries.• Make sure to insert the batteries correctly accordingto the indications of and .• Do not drop or mishandle the remote control.• Do not get the remote control wet. If the remotecontrol gets wet, wipe it dry immediately.• Avoid heat and humidity.• When not using the remote control for a long period,remove the batteries.• Do not use new and old batteries together, or usedifferent types together.• Do not take apart the batteries, heat them, or throwthem into a fire.• When using the remote control in the wirelesscondition, be sure to unplug the remote cable fromthe REMOTE IN terminal on the monitor.Caution when placing the plasma monitor in portrait mode• Use the optional mount. Contact your store to purchase before installing.• Rotate 90° clockwise as seen from the front when installing.• After installing, make sure the NEC logo is located at theleft hand side of the screen when facing the plasma fromthe front.• Be sure to set “OSM ANGLE” to “V” when using.* Failure to heed the above cautions may lead to malfunction.