NEC 60XM5, PX-60XM5A Manual Rapide

Also see for 60XM5 - PlasmaSync - 60" Plasma Panel: Supplementary guide Supplementary guide User manual Brochure & specs User manual

NEC 60XM5, PX-60XM5A Manual Rapide Manual pdf 7 page image

En-5Note:1. The VIDEO1 and RGB1 terminals can be used for either INPUT or OUTPUT.When LOOP OUT is ON, do not connect an OUTPUT signal from another unit as it may damage the other unit due to anextraordinary load.2. LOOP OUT can not be turned ON while signals are input to the RGB1 terminal.3. LOOP OUT can be turned ON while signals are input to the RGB1 terminal if the POWER is switched ON.Information• To loop signals out to another plasma display, set the LOOP OUT to ON.• To create a video wall, set the VIDEO WALL menu items properly.• To connect monitors, please use a 1 m to 2 m (3.3 feet to 6.6 feet) BNC cable (any commercially available cable).• If the image quality is poor, do not use the monitor’s out terminal. Use a distribution amplifier (any commerciallyavailable distribution amplifier) to connect the split signals to the respective monitor INPUT terminals.• Being used as a video wall function, maximaly 4-screen is rough-standard with lower than 1024768, 60 Hzsignal.• A distribution amplifier is particularly recommended when creating a 33 (or greater) video wall.• When looping from plasma to plasma, a 1 m to 2 m (3.3 feet to 6.6 feet) 15 pin male D-Sub - 5BNC conversioncable is required.Creating a video wallWith built-in matrix display capability, you can create a (22, 33, 44, 55, 51, 15) video wall.• Connect signal cables and remote cables as shown below.Video signal RGB/DVD/HD signalVIDEO(IN/OUT)(IN/OUT)AUDIO 1 DVD1 / HD 1R132( MONO)LY Cb/Pb Cr/PrRGB 2 / DVD2 / HD 2 RGB 1VDHD DV I ( Digital RGB )RLAUDIO 2( MONO)RLAUDIO 3( MONO)R/Cr/Pr G/Y B/Cb/PbRGB 3IN OUTREMOTEEXTERNAL CONTROLINOUTRemotecontrolRemotecontrolBNC connectorRCA phono plugOUTVIDEO SignalINVIDEO SignalVIDEO(IN/OUT)(IN/OUT)AUDIO 1 DVD 1 / HD1R132( MONO)LY Cb/Pb Cr/PrRGB2 / DVD2 / HD 2 RGB 1VDHD DV I ( Digital RGB )RLAUDIO 2( MONO)RLAUDIO 3( MONO)R/Cr/Pr G/Y B/Cb/PbRGB 3IN OUTREMOTEEXTERNAL CONTROLBNC connectorRGB signal/DVD/HD signalINOUTINOUTRemotecontrolRGB signal/DVD/HD signal RemotecontrolCable ManagementUsing the cable clampers and beads bands provided withthe plasma display; Bundle the signal and audio cables atthe back of the unit to connect to the display.Back of the unitmounting holesTo attachInsert q into a mounting hole, thensnap w into the back of q to fix theclamper.Clampers are designed to be difficultto undo once in place. Please attachcarefully. Cables can be routed to theright or left.To detachUsing pliers, twist the clamper 90° andpull it outward. In some cases theclamper may have deteriorated overtime and may get damaged whenremoved.Bunch separated cables together andsecure them with the provided beadsbands.Do not allow excessive stress to beplaced on the ends of cables.