NEC 90 User Manual
Also see for 90: Support document
                                    | |
Contents
| 
Quick StartFigure A.1315-pin mini D-SUBCaptive Signal CableTo attach the MultiSync® monitor to your system, follow these in-structions:1. Turn off the power to your computer.2. If necessary, install the display card into your system. For more information,refer to the display card manual.3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to theconnector of the display card in your system (Figure A.1). Tighten all screws.For the Mac: Connect the MultiSync Macintosh cable adapter (not included) tothe monitor connector on the Macintosh (Figure B.1). Attach the 15-pin miniD-SUB end of the captive signal cable to the MultiSync Macintosh cableadapter on the computer (Figure B.1). Tighten all screws.NOTE: To obtain the MultiSync Macintosh cable adapter, callNEC Technologies at (800) 820-1230.4. For download information on the Windows® 95/98 INF file for yourMultiSync monitor, refer to the References section of this User’s Manual.5. Connect one end of the power cord to the MultiSync monitor and the otherend to the power outlet (Figure C.1).6. Turn on the monitor (Figure D.1) and the computer.NOTE: If you have any problems, please refer to the Troubleshooting section ofthis User’s Manual.15500251.wpc 5/7/99, 12:54 PM5 |
Related manuals for NEC 90
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine