Placing CallsPlacing an Outside Call . . .1. (Optional) Lift handset.2. + Listen for dial tone + Outside number.• You can have function keys for lines or line groups.• If your system is behind a PBX, you may have to dial 9 before your number.OR1. (Optional) Lift handset.2. + + Outside number.OR2. + + Line group (1-9 or 001-100) + Outside number.OR2. + + Line number (e.g., 005 for line 5) + Outside number.• Call a number using the Center Telephone Book. From an idle keyset, press PROG Soft Key +DOWN ARROW Soft Key twice + TELBK Soft Key.Calling a Co-Worker, Voice Mail and Paging . . .1. (Optional) Lift handset.• For one-touch calling, press a Call Coverage or Hotline function key instead of going on tostep 2.2. + Co-worker’s extension number.• Your call will ring or voice-announce. If you hear ringing, wait for an answer. If you hear abeep, begin speaking. Dialing 1 changes mode.• For your Voice Mailbox, dial 8.• For Paging, dial 1 + 0 for All Call or 1 + 1-8 for page groups.If your call doesn’t go through . . .Camp On and Callback1. To Camp On (wait without hanging up), .• (Intercom calls) When you hear ringing, wait for the called party to answer.If you hear busy/ring instead of busy before camping on, you can optionally dial the Barge Incode to send a Voice Over. Check with your Communications Manager for the code.• (Outside calls) When you hear new dial tone, place your call again.OR1. To leave a Callback for a busy line or extension, and hang up.• Wait for the system to call you back.2. or lift handset.• (Outside calls) Place your call again.• (Intercom calls) Speak to co-worker.To cancel your Callback:1. (Optional) Lift handset.2. + + Hang up.When you hearsystem busy, useCamp On orCallback:Dial using theIntercom:Dial codes foroutside lines:Press a line key forquick access: