|
18Voice/Videophone CallsTo mute the ring toneXPress g at “Level 1”The icon on the standby screen indicates whichitems are set to “Silent”.: “Silent” is set for “Phone”, “Videophone”and/or “PushTalk”: “Silent” is set for “Mail”, “MessageR” and/or“MessageF”: Both “ ” and “ ” are setHolding Incoming/CurrentCalls 1 While ringingXyThree short beeps soundand the call is put on hold.The caller hears anannouncement that youcannot answer now, and thecall is put on hold.To put the current callon holdXDuring a callXtTo end the call during on hold/call holdXy2 Press r to resume the callYou can also press t to resume the held call.Setting the hold tone Set the announcement to be played to the callerduring on hold.z You cannot change the hold tone played during acall.1 iX“Settings/Service”X“Talk”X“Hold tone setting”X“On holdtone”XSelect a toneSelect “Tone 1”, “Tone 2”, “Voice announce 1 *” or“Voice announce 2 * ”.*: Not available when no voice announcement isrecorded.Using the Public ModePublic mode (Driving mode/Power OFF) is anautomatic answering service provided for publicplaces and circumstances in which mobile phonesshould not be used.z When Public mode and network services are setconcurrently, Voice Mail service*1 , Call Forwardingservice*1 and Caller ID Request service *2 takeprecedence over Public mode.*1: For a voice call whose ring time is not “0 second”, aservice activates after the Public modeannouncement is played.*2: When the caller notifies the caller ID, Public modeactivates.z Public mode does not work for a call from a phonenumber registered for Nuisance Call Blocking.Using Public Mode (Driving Mode)When Public mode is set, a caller hears a messagethat you cannot answer the call because you aredriving or in a place where you have to refrain fromusing a mobile phone (on a train or bus, in a theater,etc.), then the call ends.z Public mode can only be set or released from thestandby screen (can also be set or released when“ ” is displayed.).z You can make calls when Public mode is set.z This function is not available during datacommunication.z When you receive a call with no caller ID whileCaller ID Request service is set to “Activate”, thecaller ID request announcement is played (Publicmode announcement is not played.)Nz The ring volume setting specified for “Phone” inthis function is also applied to the “Select ringtone” setting for a voice call, and the alarm tonesfor “Schedule” and “To Do list”.z Even if the Ring volume is set to “Level 3” - “Level6” or “Step”, the ring tone is played at “Level 2” inthe following cases:• Immediately after a voice call/videophone callends• Immediately after a PushTalk call ends• Immediately after a Record message/Voicememo recording ends or during playback• During/immediately after “Voice announce”recordingNz Call charges apply while an incoming call orcurrent call is put on hold.
|
