NEC Express5800/R320c-E4 N8800-173F Installation Manual

Also see for Express5800/R320c-E4: User guide Configuration guide Installation guide Configuration guide Configuration guide

Contents

4. Setting Up Windows Server 2008 R2Express5800/R320c-E4, R320c-M4, R320d-E4, R320d-M4 Installation Guide (Windows)150Chapter 1 Installing Operating System4.5 Installing ft Server Control SoftwareYou must quit all programs including Microsoft management console.1. Install ft Server Control Software in the following procedure.When ft Server Control Software UPDATE media is not provided:(1) After logging on to the system as a user with the Administrative account, insert theEXPRESSBUILDER DVD into the optical disk drive of the server.(2) On the menu screen, click Integrated Installation, select ft Server Control Software on the menu,and then click Install.When ft Server Control Software UPDATE media is provided:Install ft Server Control Software from the UPDATE media according to Instruction Manual that comeswith the media.Follow the instructions to proceed with the installation.Note The message "ft Server Control Software, Now Installing... Please Wait." is displayedduring installation.Do not use the keyboard or mouse while this message is being displayed.2. When installation starts, a message "If there is a disc in the DVD drive, please remove it." will bedisplayed. If EXPRESSBUILDER DVD is set in optical disk drive, remove it.3. The system is rebooted several times during the installation. After the system is rebooted, log in again asthe user logged in before rebooting.4. Installation of the ft Server Control Software resumes after you logged on.5. When the message "Installation is finished" is displayed, click OK to reboot the server.Note Change the screen to check the message by using the taskbar, as the message may hidebehind the screen.