2. System BIOS SetupExpress5800/T110g-S User’s Guide112Chapter 3 Setup2. System BIOS SetupThis section describes how to configure Basic Input Output System (BIOS).2.1 OverviewThe BIOS Setup Utility (SETUP) is a utility to configure basic hardware settings. This utility is pre-installed inthe server as standard and can run without bootable discs.Usually, you do not need to change the parameters of the SETUP. Use only when the case applies to anyof cases described in Chapter 3 (2.4 Cases that Require Setting Changes).2.2 Starting SETUP UtilityTurn on the server and wait until the following message appears. See Chapter 3 (1.1.1 POST sequence) fordetails.Press SETUP, Internal Flash Memory, ROM Utility, NetworkWhen you press key during displaying the message or the NEC logo, SETUP runs and displays theMain menu upon completion of POST.About password entryThe entry of the password appears after you set a password in SETUP.Enter password [ ]If you enter a wrong password three times, SETUP stops. Turn off the server and try again.To exit SETUP after saving the parameters, choose Save & Exit and then Save Changes and Exit.To exit SETUP without saving the parameters, select Save & Exit and then Discard Changes and Exit.
