101TO MAKE AN EXTERNAL CALLWhen dialed telephone number is registered in Per-sonal Directory, the corresponding name informationwill be displayed on LCD of DT730 Series while youare hearing a ringback tone or are engaged in a con-versation. According to the initial settings, the displaymay differ from the following examples. For more infor-mation, contact the system administrator.STEP 1: Lift handset or press key, receive dialtone.STEP 2: Dial the Central Office access code, e.g. 9.STEP 3: Dial desired telephone number.(while hearing a ringback tone)STEP 4: Use handset or MIC to start a conversation.Display indicates:(while in a conversation)• When dialed number is registered in Personal DirectoryNote: Personal Directory Name Display function isavailable only for DT730 Series.Note: This section describes the Normal Dial Mode.Regarding the other mode, see TO ORIGINATE ACALL USING SELECTIVE DIALING (DYNAMICDIAL PAD, PRESET DIAL) in Chapter 5.DT730/710 DT330/310Speaker1:25 PM MON 12 JUL 2010MIC DND >>>31313Station Numberof My Line1:25 PM MON 12 JUL 2010MIC DND >>>9Dialed CodeNote: In the above case, a maximum of eight digits ofthe number (including “*”) can be displayed. If thedialed number exceeds eight digits, “the firstseven digits of the number + *” or “the last sevendigits of the number + *” are displayed. For moreinformation, please contact the system adminis-trator.1:25 PM MON 12 JUL 20109XXXXXXXXXMIC >>>Dialed Code + Number9XXXXXX*00:05Elapsed TimeTOM JONESMIC DND >>>Dialed CodeName Informationregistered inPersonal Directory + Number
