NEC LT260 User Manual

Also see for LT240 Series: Supplementary guide Control commands Command guide Command guide Control commands

Contents

NEC LT260 User Manual Manual pdf 19 page image

E-19Battery Installation1. Press firmly and slide the battery cover off.2. Remove both old batteries and install new ones (AA). Ensure that youhave the batteries' polarity (+/-) aligned correctly.3. Slip the cover back over the batteries until it snaps into place. Do not mixdifferent types of batteries or new and old batteries.Note on Remote Control Operation:If you press and hold the SELECT button while installing newbatteries, the remote control may fail to work properly.Should this happen, remove the batteries and then install them again with-out touching the SELECT button.INTRODUCTION Part Names of the Remote Controlhttp://www.pureglare.com.au