20PC CARDR AUDIO IN LAC INVIDEO INAUDIO OUTS-VIDEO IN PC CONTROL COMPUTER 1 IN COMPUTER 2 IN MONITOR OUTAUDIO INUSBLANAUDIO INL RAUDIO OUTL RComponentY Cb CrCOMPUTER 1 IN2. Installation and ConnectionsYou can connect your projector to a DVD player with component output or Video output. To do so, simply:1. Turn off the power to your projector and DVD player.2. If your DVD player has a component video (Y,Cb,Cr) output, use a commercially available component video cable(RCA3) and the optional 15-pin-to-RCA (female)3 cable to connect your DVD player to the COMPUTER INconnector on the projector.For a DVD player without component video (Y,Cb,Cr) output, use an S-Video cable (not provided) to connect an S-Video output of the DVD player to the Video Input of the projector.3. Connect the supplied power cable. See page 26.4. Turn on the projector and DVD player.A component signal will be automatically displayed. If not, from the menu, select [Setup] → [Options] → [SignalSelect] → [Computer 1 (or 2)] → [Component].NOTE: Refer to your DVD player's owner's manual for more information about your DVD player's video output requirements.Connecting Your DVD Player with Component OutputDVD playerAudio EquipmentAudio cable (not supplied)Optional 15-pin - to - RCA (female)3 cable(ADP-CV1)Component video RCA3cable (not supplied)
