NEC LT75Z User Manual

Contents

NEC LT75Z User Manual Manual pdf 41 page image

E-35SetupPage1 Page2 Page3 Page4Default Source SelectCommunication SpeedSelect19200bpsControl Panel Key LockClear Lamp Hour MeterDefault Source RGBUnlockedTo lock the cabinet buttons:1) Use the Select or button to select “Control Panel KeyLock” and press the ENTER button. The submenu will bedisplayed.2) Use the Select or button to select “Lock” and press theENTER button. The following confirmation screen will be dis-played.3) Use the Select or button to select “Yes” and press theENTER button.The diplay will be changed to “Control Panel Key Lock - Lock”and be returned to the previous menu screen.NOTE: When “No” is selected and the ENTER button is pressed,the displayed will not be changed and will be returned to the previ-ous menu screen.2) Use the Select or button on the remote control to se-lect “Unlock” and press the ENTER button on the remotecontrol. This change will take effect immediately.NOTE:• The confirmation screen will not be displayed.• When the cabinet buttons are locked, pressing and holding theCANCEL button for about 10 seconds will change the settingfrom Locked to Unlocked.[Clear Lamp Hour Meter]Resets the lamp clock back to zero. Selecting this option dis-plays submenu for a confirmation. To reset the lamp usagehour meter, use the or button to select “Yes”.NOTE: The projector will turn off and go into standby mode after 1100hours (up to 1600 hours in Eco mode) of service. If this happens,press the “Help” button on the remote control for ten seconds to resetthe lamp clock back to zero. Do this only after replacing the lamp.LockAre you sure ?YesNoSetupPage1 Page2 Page3 Page4Default Source SelectCommunication SpeedSelect19200bpsControl Panel Key LockClear Lamp Hour MeterDefault Source RGBUnlockedLockUnlockNOTE: The progress indicator shows the percentage of remaining bulblife.The value informs you of the amount of lamp and projector usagerespectively.InformationDisplays the status of the current signal and lamp usage. Thisdialog box has three pages. The information included are asfollows:[Page 1]Source IndexInput TerminalHorizontal FrequencyVertical FrequencySync Polarity[Page 2]Signal TypeVideo TypeSync TypeInterlace[Page 3]Remaining Lamp Time (%)*Lamp Hour Meter (H)Projector Usage (H)* When the remaining lamp timereaches 0, the Remaining LampTime bar indicator changes from0% to 100 Hours and startscounting down.If the remaining lamp timereaches 0 hours, the projector willnot turn on regardless of whetherthe lamp mode is set to Normalor Eco.This option turns on or off the Control Panel Key Lock func-tion.NOTE:• When the cabinet buttons are not locked, “Control Panel KeyLock - Unlock” will be displayed. When the cabinet buttons arelocked, “Control Panel Key Lock - Locked” will be displayed.• This Control Panel Key Lock does not affect the remote controland the PC Control functions.[Conrol Panel Key Lock] To unlock the cabinet buttons:1) Use the Select or button on the remote control to se-lect “Control Panel Key Lock” and press the ENTER buttonon the remote control. The submenu will be displayed.