1327. Maintenance❸ Replacing the LampWhen the lamp reaches the end of its life, the LAMP indicator in the cabinet will blink red and the message “THE LAMPHAS REACHED THE END OF ITS USABLE LIFE. PLEASE REPLACE THE LAMP.” will appear (*). Even though thelamp may still be working, replace the lamp to maintain the optimal projector performance. After replacing the lamp,be sure to clear the lamp hour meter. (→ page 115)CAUTION• DO NOT TOUCH THE LAMP immediately after it has been used. It will be extremely hot. Turn the projectoroff and then disconnect the power cord. Allow at least one hour for the lamp to cool before handling.• Use the specified lamp for safety and performance.To order the replacement lamp, specify your lamp type.Replacement lamp:NP30LP: M402W/M402X/M352WS/M332XSNP29LP: M362W/M362XNP28LP: M322W/M322X/M302WSNP27LP: M282X• DO NOT REMOVE ANY SCREWS except one lamp cover screw and three lamp housing screws. You could receivean electric shock.• Do not break the glass on the lamp housing.Keep finger prints off the glass surface on the lamp housing. Leaving finger prints on the glass surface might causean unwanted shadow and poor picture quality.• The projector will turn off and go into standby mode when you continue to use the projector for another 100 hoursafter the lamp has reached the end of its life. If this happens, be sure to replace the lamp. If you continue to usethe lamp after the lamp reaches the end of its life, the lamp bulb may shatter, and pieces of glass may be scatteredin the lamp case. Do not touch them as the pieces of glass may cause injury. If this happens, contact your NECdealer for lamp replacement.*NOTE: This message will be displayed under the following conditions:• for one minute after the projector has been powered on• when the (POWER) button on the projector cabinet or the STANDBY button on the remote control is pressedTo turn off the message, press any button on the projector cabinet or the remote control.Optional lamp and tools needed for replacement:• Phillips screwdriver (plus-head)• Replacement lampFlow of Replacing the LampStep 1. Replace the lampStep 2. Clear the lamp usage hours (→ page 115)
