NEC MH250 User Manual

Also see for Univerge MH250: User guide User guide

NEC MH250 User Manual Manual pdf 5 page image

Federal Communication Commission Interference Statement……………………………………………………………………………………………………This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipmentgenerates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmfulinterference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment doescause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to tryto correct the interference by one of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmfulinterference, and (2) this device must accept any interference received, including interference that may cause undesired operation.CAUTION:Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.IMPORTANT NOTE:This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operatinginstructions for satisfying RF exposure compliance. To maintain compliance with FCC RF exposure compliance requirements, please avoid directcontact to the transmitting antenna during transmitting.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.We declare that the product is limited in CH1 - CH11 by specified firmware controlled in the USA.Equipment Class : Digital Transmission SystemNotes : WLAN IP PhoneFCC Rule Parts Frequency Range(MHZ) Output Watts15C 2412.0 – 2462.0 0.02Power Output is Conducted.