NEC MULTISYNC LCD195NX User Manual

Also see for MultiSync LCD195NX: User manual

Contents

NEC MULTISYNC LCD195NX User Manual Manual pdf 6 page image

EnglishEnglish-510. Connect the power cord to the power outlet (Figure E.1).NOTE: If you have difficulty removing the cable cover, please push thelower opening upward to remove it, as show in Figure E.2.NOTE: Please refer to Caution section of this manual for proper selectionof AC power cord.11. Turn on the monitor with the front power button and the computer(Figure E.1).Figure E.1Figure E.212. No-touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial setup for most timings.For further adjustments, use the following OSD controls:• Auto Adjust Contrast• Auto AdjustRefer to the Controls section of this User’s Manual for a full description of these OSD controls.NOTE: If you have any problem, please refer to the Troubleshooting section of this User’s Manual.Figure RL.1Raise and Lower Monitor ScreenThe monitor may be raised or lowered. To raise or lowerscreen, place hands on each side of the monitor and lift orlower to the desired height (Figure RL.1).NOTE: Handle with care when raising or lowering themonitor screen.Screen PivotBefore rotating, the screen must be raised to the highest levelto avoid accidentally damaging the screen and to avoidpinching fingers. With one hand, grip the top of the display bythe handle using the other hand to grip the bottom. Lift up tothe highest position (Figure RL.1).To rotate the screen, place hands on each side of the monitorscreen and turn clockwise from Landscape to Portrait orcounter-clockwise from Portrait to Landscape (Figure R.1).NOTE: Disconnect cables before rotating the screen.Re-connect cables when screen is in desired position.Power ButtonTilt and SwivelGrasp both sides of the monitor screen with your hands and adjust the tilt and swivelas desired (Figure TS.1).NOTE: Handle with care when tilting and swivelling the monitor screen.Figure R.1Figure TS.1