NEC MultiSync FE770 User Manual

Contents

NEC MultiSync FE770 User Manual Manual pdf 5 page image

3Quick StartFigure A.1To attach the FE monitor to your system, follow these instructions:1. Turn off the power to your computer.2. If necessary, install the display card into your system. For more information,refer to the display card manual.3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to theconnector of the display card in your system (Figure A.1). Tighten all screws.For the Mac: Connect the MultiSync FE Macintosh cable adapter (not included)to the monitor connector on the Macintosh (Figure B.1). Attach the 15-pinmini D-SUB end of the captive signal cable to the MultiSync FE Macintoshcable adapter on the computer (Figure B.1). Tighten all screws.NOTE: To obtain the MultiSync FE Macintosh cable adapter, callNEC-Mitsubishi Electronics Display of America, Inc. at (800) 632-4662.4. For download information on the Windows® 95/98/Me/2000/XP INF filefor your MultiSync monitor, refer to the References section of this User’sManual.5. Connect one end of the power cord to the MultiSync FE monitor and the otherend to the power outlet (Figure C.1).6. Turn on the monitor (Figure D.1) and the computer.NOTE: If you have any problems, please refer to the Troubleshooting section ofthis User’s Manual.Figure B.1Captive Signal Cable Captive Signal Cable15-pinminiD-SUBMac Adapter(Not Included)MSFE770Manual.wpc 2/6/02, 4:53 PM3