NEC MultiSync FP1355 User Manual

Also see for MultiSync FP1355 FP1355 FP1355: Dimensional drawing User manual User manual Service manual

Contents

Quick Start3To attach the MultiSync FP 1355 monitor to your system, followthese instructions:1. Turn off the power to your computer.2. If necessary, install the display card into your system. For more information,refer to the display card manual.3. For the PC: Connect the 15-pin mini D-SUB or DVI-A connector of the captivesignal cable to the connector of the display card in your system (Figure A.1).Tighten all screws.NOTE: This monitor does not work on DVI digital.For the Mac: Connect the MultiSync FP1355 Macintosh cable adapter (notincluded) to the monitor connector on the Macintosh (Figure B.1). Attach the15-pin mini D-SUB end of the captive signal cable to the MultiSync FP1355Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.NOTE: To obtain the MultiSync FP1355 Macintosh cable adapter, contactNEC Australia Pty. Ltd.4. For download information on the Windows® 95/98/2000/Me INF file foryour MultiSync monitor, visit www.necmitsubishi.com.5. Connect one end of the power cord to the MultiSync FP1355 monitor and theother end to the power outlet (Figure C.1).6. Turn on the monitor (Figure D.1) and the computer.NOTE: If you have any problems, please refer to the Troubleshooting section ofthis User’s Manual.USB Cable DetachableSignal CableDVI-A15-pin mini D-SUBFigure A.1