NEC MultiSync JC-1941UMA User Manual

Contents

NEC MultiSync JC-1941UMA User Manual Manual pdf 4 page image

Quick StartFigure A.1215-pin mini D-SUBCaptive Signal CableTo attach the MultiSync® E900™ monitor to your system, follow theseinstructions:1. Turn off the power to your computer.2. If necessary, install the display card into your system. For more information,refer to the display card manual.3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to theconnector of the display card in your system (Figure A.1). Tighten all screws.For the Mac: Connect the MultiSync E900 Macintosh cable adapter (notincluded) to the monitor connector on the Macintosh (Figure B.1). Attach the15-pin mini D-SUB end of the captive signal cable to the MultiSync E900Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.NOTE: To obtain the MultiSync E 900 Macintosh cable adapter, callNEC Technologies at (800) 820-1230.4. Connect one end of the power cord to the MultiSync E900 monitor and theother end to the power outlet (Figure C.1).5. Turn on the monitor (Figure D.1) and the computer.NOTE: If you have any problems, please refer to the Troubleshooting section ofthis User’s Manual.Untitled-1 6/15/98, 1:24 PM4