NEC MultiSync LCD1570NX User Manual

Also see for LCD1570NX - MultiSync - 15" LCD Monitor: Specifications Specifications Specifications Specification sheet Brochure & specs

NEC MultiSync LCD1570NX User Manual Manual pdf 17 page image

15TroubleshootingNo picture• The signal cable should be completely connected to the display card/computer.• The display card should be completely seated in its slot.• Check the Vacation Switch should be in the ON position.• Front Power Switch and computer power switch should be in the ON position.• Check to make sure that a supported mode has been selected on the display card or systembeing used. (Please consult display card or system manual to change graphics mode.)• Check the monitor and your display card with respect to compatibility and recom-mended settings.• Check the signal cable connector for bent or pushed-in pins.Power Button does not respond• Unplug the power cord of the monitor from the AC outlet to turn off and reset themonitor.• Check the Vacation Switch on the back side of the monitor.Image Persistence• Please be aware that LCD Technology may experience a phenomena known asImage Persistence. Image Persistence occurs when a residual or “ghost” image of aprevious image remains visible on the screen. Unlike CRT monitors, LCD monitors’image persistence is not permanent, but constant images being displayed for a longperiod of time should be avoided.To alleviate image persistence, turn off the monitor for as long as the previousimage was displayed. For example, if an image was on the monitor for one hourand a residual image remains, the monitor should be turned off for one hour toerase the image. As with all personal display devices, NEC DISPLAY SOLUTIONSrecommends displaying moving images and using a moving screen saver at regularintervals whenever the screen is idle or turning off the monitor when not in use.Image is unstable, unfocused or swimming is apparent• Signal cable should be completely attached to the computer.• Use the OSM Image Adjust controls to focus and adjust display byincreasing or decreasing the fine total. When the display mode is changed, the OSMImage Adjust settings may need to be re-adjusted.• Check the monitor and your display card with respect to compatibilityand recommended signal timings.• If your text is garbled, change the video mode to non-interlace and use 60Hz refresh rate.LED on monitor is not lit (no green or amber color can be seen)• Power Switch should be in the ON position and power cord should be connected.Display image is not sized properly• Use the OSM Image Adjust controls to increase or decrease the Coarse total.• Check to make sure that a supported mode has been selected on the display card or systembeing used. (Please consult display card or system manual to change graphics mode.)No Video• If no video is present on the screen, turn the Power button off and on again.• Make certain the computer is not in a power-saving mode (touch the keyboard or mouse).LCD1570NXmanual051105.pmd 5/11/05, 1:06 PM15