NEC MultiSync LCD175VXM+ User Manual

Also see for L174F1: User manual

Contents

English-12Specifications for MultiSync LCD195VXM+Monitor Specifications MultiSync LCD195VXM+ Monitor NotesLCD Module Diagonal: 48 cm/19 inches Active matrix; thin film transistor (TFT)Viewable Image Size: 48 cm/19 inches liquid crystal display (LCD); 0.294 mm dotNative Resolution (Pixel Count): 1280 x 1024 pitch; 300 cd/m 2 * 2 white luminance,800:1 contrast ratio, typical;response time: 5 ms.Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms Digital Input: DVI-DSync: Separate sync.TTL Level (Positive/Negative)Horizontal sync. Positive/NegativeVertical sync. Positive/NegativeDisplay Colours Analog input: 16,7 M Depends on display card used.Synchronization Range Horizontal: 31.5 kHz to 81.1 kHz AutomaticallyVertical: 56 Hz to 76 Hz AutomaticallyViewing Angle Left/Right: -80°/+80° (CR>10), -88°/+88° (CR>5)Up/Down: -75°/+85° (CR>10), -85°/+85° (CR>5)Resolutions Supported Landscape: 720 x 400* 1 : VGA Some systems may not640 x 480* 1 @ 60 Hz to 75 Hz support all modes listed.800 x 600* 1 @ 56 Hz to 75 Hz832 x 624* 1 @ 75 Hz1024 x 768* 1 @ 60 Hz to 75 Hz1152 x 864* 1 @ 70 Hz1152 x 870* 1 @ 75 Hz1280 x 960* 1 @ 60 Hz to 75 Hz Recommended resolution is 60 Hz for1280 x 1024 @ 60 Hz to 75 Hz................... optimal display performance.Active Display Area Horizontal: 376.3 mmVertical: 301.1 mmSpeakers Practical Audio Output: 1.0 W + 1.0 WPower Supply 100 - 240 V ~ 50/60 HzPower Consumption 40 WDimensions Landscape: 405.5 mm (W) x 385.8 - 435.8 mm (H) x 240.0 mm (D) (with stand)405.5 mm (W) x 345.5 mm (H) x 66.5 mm (D) (without stand)Weight with stand: 6.0 kgwithout stand: 5.0 kgEnvironmental ConsiderationsOperating Temperature: 5 °C to 35 °CHumidity: 30% to 80%Altitude: 0 to 3,048 mStorage Temperature: -10 °C to +60 °CHumidity: 10% to 85%Altitude: 0 to 12,192 m*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This isnormal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot onthe screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.*2 LCD Module at 25°C.NOTE: Technical specifications are subject to change without notice.