NEC MultiSync LCD1770VX User Manual

Also see for LCD1770VX - MultiSync - 17" LCD Monitor: Specifications Specifications Brochure & specs

NEC MultiSync LCD1770VX User Manual Manual pdf 5 page image

3Display SetupTo attach the MultiSync® LCD monitor to your system, follow these instructions:1. Turn off the power to your computer.2.For the PC or MAC with DVI digital output : Connect the DVI signal cable to theconnector of the display card in your system (Figure 1). Tighten all screws.For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to theconnector of the display card in your system (Figure 2). Tighten all screws.For MAC setup: Connect the Macintosh cable adapter to the computer, then attach the15-pin mini D-SUB signal cable to the Macintosh cable adapter (Figure 3). Tighten allscrews.NOTE: To obtain the MultiSync Macintosh cable adapter, call NEC Display Solutionsof America, Inc. at (800) 632-4662.3. Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and liftup to the highest position (Figure 4).4. Connect all cables to the appropriate connectors (Figure 4).NOTE: If connecting both DVI and D-sub cable, the DVI cable must be connectedalong side of the rib on the power cord side (Figure 4).5. For successful cable management, it is suggested that the cables be placed in thisorder: power cable and DVI cable (Figure 5).6. Place DVI cable and power cable into the specific hooks indicated in (Figure 6).7. Place the D-Sub into the specific hook indicated in (Figure 7).8. Make sure all cables are resting flat against the stand (Figure 7).9. Hold all cables firmly and place the cable cover onto the stand (Figure 8). To removethe cable cover, lift the cover off as shown in (Figure 9).10. Connect the power cord to the power outlet (Figure 11).NOTE: If you have difficulty removing the cable cover, please push the notch at thebottom of the cover up (towards the top of the monitor)in order to unhook the coverfrom the stand. (Figure 10).NOTE: If you use this monitor at AC125-240V, please refer to Recommended Usesection of this manual for proper selection of power cord.11. The vacation switch on the back side of the monitor must be turned on (Figure 11).Turn on the monitor with the front power button and power on the computer.NOTE: The vacation switch is a true on/off switch. If this switch is in the OFFposition, the monitor cannot be turned on using the front button. DO NOT switchon/off repeatedly.12. Analog input only: No-Touch Auto Adjust automatically adjusts the monitor to optimalsettings upon initial setup most of the time. For further adjustments, use the followingOSM ® controls:• Auto Adjust Contrast • Auto AdjustRefer to the Controls section of this User ’s Manual for a full description of theseOSM controls.NOTE: For download information on the Windows® 95/98/Me/2000/XP INF file foryour monitor, refer to the References section of this User’s Manual.NOTE: If you have any problems, please refer to the Troubleshooting section of thisUser’s Manual.LCD1770VX042205.pmd 4/26/05, 9:49 AM3