EnglishEnglish-3Figure 1 Figure 2ContentsYour new NEC MultiSync LCD monitor box* should contain the following:• MultiSync LCD monitor with tilt base• Audio Cable• Power Cord• Video Signal Cable (15-pin mini D-SUB male to 15-pin mini D-SUB male)• Video Signal Cable (DVI-D to DVI-D) (LCD195VXM+ only)• User’s Manual• CD-ROM• Cable management cover*Remember to save your original box and packing material to transport or ship the monitor.Quick StartTo pull the stand, follow these instructions:1. Place monitor face down on a non-abrasive surface (Figure 1).2. Pull the stand holding the monitor with the other hand until the stand clicks (Figure 2).NOTE: Handle with care when pulling the stand.User’s Manual Audio Cable Power Cord 15-pin mini D-SUBmale to 15-pin miniD-SUB maleDVI-D to DVI-D(LCD195VXM+ only) MultiSync LCD monitorCD-ROMCable managementcoverFigure A.1 Figure A.3MacintoshCable Adapter(not included)Figure A.2NOTE: Reverse this procedure if you need to re-pack the monitor.To attach the MultiSync LCD monitor to your system, follow these instructions:1. Turn off the power to your computer.2. For the PC or MAC with DVI digital output: Connect the DVI-D signal cable to the connector of the display card in yoursystem (Figure A.1). Tighten all screws.For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in yoursystem (Figure A.2). Tighten all screws.For the Mac: Connect the MultiSync Macintosh cable adapter (not included) to the computer. Attach the 15-pin miniD-SUB signal cable to the MultiSync Macintosh cable adapter (Figure A.3). Tighten all screws.NOTE: Some Macintosh systems do not require a Macintosh cable adapter.