NEC MultiSync LCD1970NX Service Manual

Also see for MultiSync LCD1970NX: Specifications Specifications Specifications Brochure & specs Specifications

NEC MultiSync LCD1970NX Service Manual Manual pdf 17 page image

1-14English-12Specifications for LCD1970VMonitor Specifications MultiSync LCD1970V Monitor NotesLCD Module Diagonal: 48.2 cm/19.0 inches Active matrix; thin film transistor (TFT)Viewable Image Size: 48.2 cm/19.0 inches liquid crystal display (LCD); 0.294 mm dotNative Resolution (Pixel Count): 1280 x 1024 pitch; 250 cd/m 2 white luminance;450:1 contrast ratio, typical.Input Signal Video: ANALOG 0.7 Vp-p/75 OhmsSync: Separate sync.TTL LevelHorizontal sync. Positive/NegativeVertical sync. Positive/NegativeComposite sync. Positive/Negative* 2Sync on Green (Video 0.7 Vp-p and Sync. 0.3 Vp-p)* 2Display Colours 16,777,216 Depends on display card used.Synchronization Range Horizontal: 31.5 kHz to 81.1 kHz AutomaticallyVertical: 56.0 Hz to 75.0 Hz AutomaticallyViewing Angle Left/Right: 80°/80° (CR > 5)Up/Down: 80°/80° (CR > 5)Resolutions Supported 720 x 400* 1 : VGA-Text Some systems may not support all modes640 x 480* 1 at 60 Hz to 75 Hz listed.800 x 600* 1 at 56 Hz to 75 Hz832 x 624* 1 at 75 Hz1024 x 768* 1 at 60 Hz to 75 Hz1152 x 870* 1 at 75 Hz1280 x 1024 at 60 Hz to 75 Hz NEC-Mitsubishi Electronics Display citesrecommended resolution at 60 Hz foroptimal display performance.Active Display Area Horizontal: 376.3 mm/14.8 inchesVertical: 301.1 mm/11.9 inchesPower Supply AC 100-240V ~ 50/60HzPower Consumption 36W (typ)(without optional Sound Bar)Current Rating 0.65-0.35ADimensions 412.5 mm (W) x 386.5-496.5 mm (H) x 220.0 mm (D)16.2 inches (W) x 15.2-19.5 inches (H) x 8.7 inches (D)Weight 7.0 kg (15.4 lbs)Environmental ConsiderationsOperating Temperature: 5°C to 35°C/41°F to 95°FHumidity: 30% to 80%Feet: 0 to 10,000 FeetStorage Temperature: -10°C to 60°C/14°F to 140°FHumidity: 10% to 85%Feet: 0 to 30,000 Feet*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This isnormal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot onthe screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.*2 If your display is not showing a picture of the SOG and Composite Sync. Signal, please contact our hotline for further assistance.NOTE: Technical specifications are subject to change without notice.