NEC MultiSync LCD1970V User Manual

Also see for LCD1970NX-BK - MultiSync - 19" LCD Monitor: Brochure & specs Specifications

NEC MultiSync LCD1970V User Manual Manual pdf 20 page image

18TroubleshootingNo picture• The signal cable should be completely connected to the display card/computer.• The display card should be completely seated in its slot.• Make sure the Vacation Switch is in the ON position.• Front Power Switch and computer power switch should be in the ON position.• Check to make sure that a supported mode has been selected on the display card or sys-tem being used. (Please consult display card or system manual to change graphics mode.)• Check the monitor and your display card with respect to compatibility and recom-mended settings.• Check the signal cable connector for bent or pushed-in pins.• Check the signal input, “INPUT 1” or “INPUT 2”.Power Button does not respond• Unplug the power cord of the monitor from the AC outlet to turn off and reset themonitor.• Check the Vacation Switch on the back side of the monitor.Image Persistence• Please be aware that LCD Technology may experience a phenomenon known asImage Persistence. Image Persistence occurs when a residual or “ghost” image of aprevious image remains visible on the screen. Unlike CRT monitors, LCD monitors’image persistence is not permanent, but constant images being displayed for a longperiod of time should be avoided.To alleviate image persistence, turn off the monitor for as long as the previous imagewas displayed. For example, if an image was on the monitor for one hour and aresidual image remains, the monitor should be turned off for one hour to erase theimage.As with all personal display devices, NEC DISPLAY SOLUTIONS recommends display-ing moving images and using a moving screen saver at regular intervals wheneverthe screen is idle or turning off the monitor when not in use.Image is unstable, unfocused or swimming is apparent• Make sure Signal cable is properly attached.• Use the OSM Image Adjust controls to focus and adjust display byincreasing or decreasing the fine total. When the display mode is changed, the OSMImage Adjust settings may need to be re-adjusted.• Check the monitor and your display card with respect to compatibilityand recommended signal timings.• If your text is garbled, change the video mode to non-interlace and use 60Hz refresh rate.LED on monitor is not lit (no green or amber color can be seen)• Power Switch should be in the ON position and power cord should be connected.• Make sure the Vacation Switch is in the ON position.Display image is not sized properly• Use the OSM Image Adjust controls to increase or decrease the H.SIZE.• Check to make sure that a supported mode has been selected on the display card or systembeing used. (Please consult display card or system manual to change graphics mode.)No Video• If no video is present on the screen, turn the Vacation Switch off and on again.• Make certain the computer is not in a power-saving mode (touch the keyboard or mouse).