NEC MultiSync LCD1990SX User Manual

Also see for LCD1990SX - MultiSync - 19" LCD Monitor: Specifications User manual Specifications User manual Specifications

NEC MultiSync LCD1990SX User Manual Manual pdf 14 page image

English-10RESOLUTION NOTIFIERThis optimal resolution is 1280 x 1024. If ON is selected, a message will appear on the screen after 30 seconds,notifying you that the resolution is not at 1280 x 1024.HOT KEYYou can adjust the brightness and contrast directly. When this function is set to ON, you can adjust the brightnesswith “Left” or “Right”, contrast with “Down” or “Up” buttons, while the OSD menu is off. The standard OSD can beaccessed with the MENU button.FACTORY PRESETSelecting Factory Preset allows you to reset all OSD control settings (BRIGHTNESS, CONTRAST, ECOMODE,AUTO BRIGHTNESS, BLACK LEVEL, IMAGE CONTROL, COLOR CONTROL SYSTEM, SHARPNESS, OFFTIMER, OFF MODE, OSD LEFT/RIGHT, OSD UP/DOWN, OSD TURN OFF, OSD TRANSPARENCY) back to thefactory settings. Individual settings can be reset by highlighting the control to be reset and pressing the RESETbutton.InformationProvides information about the current resolution display and technical data including the preset timing being usedand the horizontal and vertical frequencies. Indicates the model and serial numbers of your monitor.OSD WarningOSD Warning menus disappear with EXIT button.NO SIGNAL: This function gives a warning when there is no Horizontal or Vertical Sync. After power isturned on or when there is a change of input signal, the No Signal window will appear.RESOLUTION NOTIFIER: This function gives a warning of use with optimized resolution. After power isturned on or when there is a change of input signal or the video signal doesn’t have proper resolution, theResolution Notifier window will open. This function can be disabled in the TOOL menu.OUT OF RANGE: This function gives a recommendation of the optimized resolution and refresh rate. Afterthe power is turned on or there is a change of input signal or the video signal doesn’t have proper timing,the Out Of Range menu will appear.NOTE: It is possible to change the DVI SELECTION or to change the OFF MODE settings while the“NO SIGNAL” or “OUT OF RANGE” messages are displayed.For advanced user menu see “Appendix”.01_English 18/6/07, 10:57 AM10