EnglishEnglish-13SpecificationsMonitor Specifications MultiSync LCD2070WNX Monitor NotesLCD Module Diagonal: 51.1 cm/20.1 inches Active matrix; thin film transistor (TFT)Viewable Image Size: 51.1 cm/20.1 inches liquid crystal display (LCD); 0.258 mm dotNative Resolution (Pixel Count): 1680 x 1050 pitch; 300 cd/m 2 white luminance; 500:1contrast ratio, typical.Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms Digital Input: DVI-DSync: Separate sync.TTL Level Positive/NegativeHorizontal sync. Positive/NegativeVertical sync. Positive/NegativeComposite sync. Positive/Negative* 2Sync on Green (Video 0.7 Vp-p and Sync. Negative 0.3 Vp-p)* 2Display Colours 16,194,277 Depends on display card used.Synchronization Range Horizontal: 31.5 kHz to 82.3 kHz AutomaticallyVertical: 56.0 Hz to 75.0 Hz AutomaticallyViewing Angle Left/Right: 80°/80° (CR > 5)Up/Down: 75°/70° (CR > 5)Resolutions Supported 720 x 400* 1: VGA text Some systems may not support all modes640 x 480* 1 at 60 Hz to 75 Hz listed.800 x 600* 1 at 56 Hz to 75 Hz832 x 624* 1 at 75 Hz1024 x 768* 1 at 60 Hz to 75 Hz1152 x 864* 1 at 75 Hz1152 x 870* 1 at 75 Hz1280 x 960* 1 at 60 Hz to 75 Hz1280 x 1024* 1 at 60 Hz to 75 Hz1440 x 900* 1 at 60 Hz Recommended resolution is 60 Hz for1680 x 1050 at 60 Hz.................................. optimal display performance.Active Display Area Horizontal: 433.0 mm/17.0 inchesVertical: 271.0 mm/10.7 inchesUSB Hub I/P: USB Specification Revision 2.0Port: Upstream 1Downstream 4Load Current: Maximum 0.5A per portPower Supply AC 100-240V ~ 50/60HzPower Consumption 74 W (typ)(without optional Sound Bar)Current Rating 1.3 - 0.7 ADimensions 471.4 mm (W) x 371.3 - 481.3 mm (H) x 220.0 mm (D)18.6 inches (W) x 14.6 - 18.9 inches (H) x 8.7 inches (D)Weight 8.5 kg (18.7 lbs)Environmental ConsiderationsOperating Temperature: 5°C to 35°C/41°F to 95°FHumidity: 30% to 80%Altitude: 0 to 10,000 FeetStorage Temperature: -10°C to 60°C/14°F to 140°FHumidity: 10% to 85%Altitude: 0 to 30,000 Feet*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This isnormal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot onthe screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.*2 If your display is not showing a picture of the SOG and Composite Sync. Signal, please contact our hotline for further assistance.NOTE: Technical specifications are subject to change without notice.