NEC MultiSync LCD2170NX User Manual

Also see for MultiSync LCD2170NX: Specifications Specifications User manual Brochure & specs User manual

NEC MultiSync LCD2170NX User Manual Manual pdf 11 page image

EnglishEnglish-3Quick StartTo attach the MultiSync LCD monitor to your system, follow these instructions:1. Turn off the power to your computer.2. For the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in yoursystem (Figure A.1). Tighten all screws.For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in yoursystem (Figure A.2). Tighten all screws.For the MAC: Connect the Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable tothe Macintosh cable adapter (Figure B.1). Tighten all screws.NOTE: Some Macintosh systems do not require a Macintosh cable adapter.3. Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position (Figure C.1).4. Connect all cables to the appropriate connectors (Figure C.1).NOTE: If connecting both DVI and D-sub cable, the DVI cable must be connected along side the rib on the power cord side(Figure C.1).5. For successful cable management, place the cables in this order into the cable management: Power cord and DVI cable(Figure C.2).6. Place DVI cable and power cord into the specific hooks indicated in Figure C.2.7. Place the D-Sub and the USB cable into the specific hooks indicated in Figure C.2.Figure A.1 Figure B.1MacintoshCable Adapter(not included)Figure A.2DVI signal cableHighestStandPosition30˚ TiltD-SUB CablePower CordFigure C.1 Figure C.2USB CableDVI CablePower CordDC-OUTNEC optional product attachment.Do not use this connector unless specified.USBInput1 (DVI)Input2 (D-Sub)DVI Cable01_English 19/12/06, 3:07 PM3