NEC MultiSync M500 User Manual

Also see for MultiSync M700: User manual User manual Installation guide Setup guide

Contents

NEC MultiSync M500 User Manual Manual pdf 4 page image

15-pin mini D-SUBCaptive CombinedSignal CableMac Adapter(Not included)15-pin mini D-SUBComputerCaptive CombinedSignal CableQuick StartTo attach the MultiSync® M Series monitor to your system, followthese instructions:1. Turn off the power to your computer and MultiSync monitor.2. If necessary, install the display card into your system. For more information,refer to the display card manual.3. For the PC: Connect the MultiSync M Series 15-pin mini D-SUB of the captivecombined signal cable to the connector of the display card in your system(Figure A.1). Tighten all screws.2Figure A.1For the Mac: Connect the MultiSync M Series Macintosh cable adapter (notincluded) to the monitor connector on the Macintosh (Figure B.1). Attach the15-pin mini D-SUB end of the captive combined signal cable to the Macintoshcable adapter on the computer (Figure B.1). Tighten all screws.NOTE: To obtain the MultiSync M Series cable adapter, callNEC Technologies at (800) 820-1230.Figure B.178133441 6/24/98, 7:50 AM4