Ofrecido por www.electromanuales.comE-22Connecting Your PC Or MacintoshComputerConnecting your PC or Macintosh computer to your MultiSyncMT1035 (XGA) Projector will enable you to project yourcomputer's screen image for an impressive presentation. All ofthese following display standards are supported:To connect to a PC, Macintosh or computer equipped with anXGA/SVGA /VGA adapter or compatible graphics adapter,simply:1. Turn off the power to your projector and computer.2. If your PC does not support XGA/SVGA/VGA you will needto install an XGA/SVGA/VGA graphics board. Consult yourcomputer's owner's manual for your XGA/SVGA/VGA con-figuration. If you need to install a new board, see the manualthat comes with your new graphics board for installationinstructions.3. Use the signal cable that's supplied to connect your PC orMacintosh computer to the projector. For a Macintosh, usethe supplied pin adapter to connect to your Mac's video port.4. Turn on the projector and the computer.5. If the projector goes blank after a period of inactivity, it maybe caused by a screen saver installed on the computer you'veconnected to the projector.When using a Macintosh with the MT1035, set the DIP switchesof the supplied pin adapter according to your resolution. Aftersetting, restart your Macintosh.See the following pages for setting of the DIP switches.• When using with a Macintosh, XGA/VGA/SVGA (10242768)is recommended if your Macintosh supports this mode.• When using with a Macintosh PowerBook, output may notbe set to 10242768 unless “mirroring” is off on yourPowerBook. Refer to owner’s manual supplied with yourMacintosh computer for mirroring.NOTE: A Video Adapter cable manufactured by Apple Com-puter is needed for a PowerBook which does not have a mini D-Sub 15-pin connector.VGA 6402480 for graphics VGA 6402400 for graphicsVGA 6402350 for graphics VGA 7202400 for textVGA 7202350 for text SuperVGA 8002600Macintosh at 6402480 Macintosh at 8322624XGA10242768 Macintosh at 10242768SXGA128021024 (AccuBlend)Settings for Monitor ModeNumber of DIP switchMonitor size15” multi-scan mode /16”–13”17” multi-scan mode /19”–13”19” multi-scan mode /21”–13”13” fixed mode /6402480VGA/SVGA mode16” fixed mode /832262419” fixed mode /10242768S1ONONONONS2 S3 S4ONS5ONONS6ONS7ONS8ONNOTE: For settings other than display modes supported by yourMacintosh and MT1035, use of the DIP switch may bounce a imageslightly or may display nothing. If this happens, set the DIP switchto the 13” fixed mode and then restart your Macintosh. After that,restore to a displayable mode and then restart the Macintosh again.Make sure that the MT1035 and your Macintosh are connectedwith the pin adapter and the supplied signal cable (mini D-Sub 15-pin connector) and then restart your Macintosh.