NEC MultiSync PA322UHD User Manual

Contents

English-31EnglishSelf CalibrationSimply connect the external USB color sensor, and re-calibrate the factory settings without the need of a computer. This featureis to compensate for a yellow color shift that typically occurs with long-term LCD usage. All PICTURE MODES are updatedwhen Self Calibration is performed.Before proper self calibration can be performed, display should warm-up for a minimum 30 minutes. If this calibration is startedbefore the monitor is warmed up, a warning will appear on-screen (Figure S.2).NOTE: Stand-alone calibration can only be performed using the MDSVSENSOR3.Refer to the KEY MAP (Figure A) when changing settings during the calibration.Calibration can be performed in either portrait or landscape orientation.NOTE: You can start calibration without computer as following.When there is “NO SIGNAL” menu, press “LEFT”, then “RIGHT” button and hold down simultaneously. All WhitePattern Image will be displayed. After this, Plug-in the USB color sensor to the side (or bottom when Portraitorientation) USB downstream port. You can start Self Calibration from step number 4.USB downstreamUSB color sensorUSB iconis on theother sideFigure S.1Figure AKEY MAPUP/DOWN: Changes from setting to settingLEFT/RIGHT: Changes the setting selection(ie...SELF or COPY)SELECT: Moves to the next step of calibrationEXIT: Moves back one step of calibration1. Select STAND-ALONE CALIBRATION in Tag B in Advanced OSD menu.2. Unplug the USB equipment from the side (or bottom when Portrait orientation) USB downstream port and press “SELECT”.3. Plug-in the USB color sensor to the side (or bottom when Portrait orientation) USB downstream port (Figure S.1).4. The calibration menu will open and the sensor will begin to initialize.Figure S.25. Use “LEFT” or “RIGHT” to select SELF in the MODE selection. Press “UP” or “DOWN” to move to the next selection.