NEC MultiSync V422 User Manual

Also see for MultiSync V422: Specifications Control guide Manual Manual Installation guide

NEC MultiSync V422 User Manual Manual pdf 15 page image

English-13English1. Determine the installation locationCAUTION: Installing your LCD monitor must be done by aqualifi ed technician. Contact your dealer for moreinformation.CAUTION: MOVING OR INSTALLING THE LCD MONITORMUST BE DONE BY TWO OR MORE PEOPLEFOR V422/V462, BY FOUR OR MORE PEOPLEFOR V551/V651. Failure to follow this cautionmay result in injury if the LCD monitor falls.CAUTION: Do not mount or operate the monitor upsidedown, face up, or face down.CAUTION: This LCD has a temperature sensor and coolingfan. If the LCD becomes too hot, the cooling fanwill turn on automatically. If the LCD becomesoverheated while the cooling fan is running, a“Caution” warning will appear. If the “Caution”warning appears, discontinue use and allow theunit to cool. Using the cooling fan will reducethe likelihood of early circuit failure and mayhelp reduce image degradation and “ImagePersistance”.If the LCD is used in an enclosed area or if theLCD panel is covered with a protective screen,please check the inside temperature of themonitor by using the “HEAT STATUS” controlin the OSD (see page 25). If the temperature ishigher than the normal operating temperature,please turn the cooling fan to ON within the FANCONTROL menu within the OSD (see page 25).IMPORTANT: Lay the protective sheet, which was wrappedaround the LCD monitor when it waspackaged, beneath the LCD monitor so as notto scratch the panel.2. Install the remote control batteriesThe remote control is powered by two 1.5V AA batteries.To install or replace batteries:A. Press and slide to open the cover.B. Align the batteries according to the (+) and (–) indicationsinside the case.C. Replace the cover.CAUTION: Incorrect usage of batteries can result in leaks orbursting.NEC recommends the following battery use:• Place “AA” size batteries matching the (+) and (-) signson each battery to the (+) and (-) signs of the batterycompartment.• Do not mix battery brands.• Do not combine new and old batteries. This can shortenbattery life or cause liquid leakage of batteries.• Remove dead batteries immediately to prevent batteryacid from leaking into the battery compartment.• Do not touch exposed battery acid, it may injure skin.NOTE: If you do not intend to use the Remote Control fora long period of time, remove the batteries.3. Connect external equipment(See pages 15 and 16)• To protect the external equipment; turn off the main powerbefore making connections.• Refer to your equipment user manual for furtherinformation.NOTE: Do not connect/disconnect cables when turningon the monitor or other external equipment as thismay result in a loss of the monitor image.4. Connect the supplied power cord• The equipment should be installed close to an easilyaccessible power outlet.• Fully insert the prongs into the power outlet socket.A loose connection may cause image degradation.• Place the power cord within the cable holder.NOTE: Please refer to the “Safety Precautions andMaintenance” section of this manual for properselection of AC power cord.Setup