1. Installing Internal Optional DevicesExpress5800/R110f-1E User’s Guide 87Chapter 2 PreparationsImportant Do not touch the terminal part of riser cards or PCI cards and the signal pinsof electric parts installed on the card. Installing cards with dirt or oil cancause malfunction.Tips If you have trouble installing the card, remove the card once and try again. If youapply excessive pressure on the card, a PCI card or riser card might break.Note • Make sure that the head of a PCI card bracket is seated into the fixed slot.• Depending on type of PCI cards, the terminal part of the PCI card may be toolarge to fit in the connector.7. Fix the PCI card with the screw you removed in step 5.Tips If the cable which is to be connected to the connector on the motherboard of theserver is provided on the board, connect it to the board before installing the risercard to the server.8. Connect the riser card to the motherboard slot and fix the card with the screwyou removed in step 3.When connecting the card, position theterminal part of the card to the slot on themotherboard and insert it.9. Attach the removed components.10. Turn on the server and make sure that no error messages are displayed on POST screen.For details on POST error messages, refer to Chapter 3 (1. POST Error Message) in "MaintenanceGuide".11. Start the BIOS Configuration utility installed on the mounted board to set up the board.Availability or startup and operation procedure of the utility depends on board. For details, refer to themanual that comes with the board. If a PCI card including RAID Controller, SAS controller, and LANcard which connects to any bootable device is added, the boot priority might be changed to the defaultsetting. In that case, configure the boot priority in the Boot menu of the BIOS Setup utility. For detailsabout the Boot menu, refer to Chapter 2 (1.2.5 Boot) in "Maintenance Guide".PCI 1B slot PCI 1A slot
