132. Projecting an Image (Basic Operation) Connecting Your Computer/Connecting the Power Cord1. Connect your computer to the projector.This section will show you a basic connection to a computer. For information about other connections, see “(2)Making Connections” on page 143.Connect the computer cable (VGA) between the projector’s COMPUTER 1 IN connector and the computer’s port(mini D-Sub 15 Pin). Turn two thumb screws of both connectors to fix the computer cable (VGA).2. Connect the supplied power cord to the projector.First connect the supplied power cord’s three-pin plug to the AC IN of the projector, and then connect the otherplug of the supplied power cord in the wall outlet.The projector’s power indicator will light orange* (standby mode).The STATUS indicator will also light green*.* This will apply for both indicators when [NORMAL] is selected for [STANDBY MODE]. See the Power Indicatorsection.(→ page 214)COMPUTER 1 INMake sure that the prongs are fully inserted intoboth the AC IN and the wall outlet.To wall outletCAUTION:Parts of the projector may become temporarily heated if the projector is turned off with the POWER button or if theAC power supply is disconnected during normal projector operation.Use caution when picking up the projector.
