NEC NP-V311W User Manual

Contents

NEC NP-V311W User Manual Manual pdf 31 page image

213. Projecting an Image (Basic Operation)Note on Startup screen (Menu Language Select screen)When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select oneof the 27 menu languages.To select a menu language, follow these steps:1. Use the △, ▽, ◁ or ▷ button to select one of the 27languages from the menu.2. Press the ENTER button to execute the selection.After this has been done, you can proceed to the menuoperation.If you want, you can select the menu language later.(→ [LANGUAGE] on page 54 and 65)NOTE:• If one of the following things happens, the projector will not turn on.- If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this condition theprojector will not turn on to protect the internal system. If this happens, wait for the projector’s internal components to cooldown.- When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.- If the STATUS indicator lights orange as long as the POWER button is pressed, it means the CONTROL PANEL LOCK has beenset.- If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute and then turnon the power.• The projector cannot be turned off with the ON/STAND BY button or the POWER OFF button while the POWER indicator is flashinggreen in a cycle of 0.5 second on and 0.5 second off.• Do not disconnect the AC power supply to the projector for 60 seconds immediately after turning it on and displaying an image.• Immediately after turning on the projector, screen flicker may occur. This is normal. Wait 3 to 5 minutes until the lamp lighting isstabilized.• If you turn on the projector immediately after the lamp is turned off or when the temperature is high, the fans run without display-ing an image for some time and then the projector will display the image.