NEC NP1000 Network Setup Manual

Also see for NP1000: Specifications Supplementary guide Control commands Control commands Placement recommendations guide

Contents

NEC NP1000 Network Setup Manual Manual pdf 13 page image

114. Attaching Wireless LAN CardAttaching Wireless LAN Card44. Attaching Wireless LAN CardInsert the wireless LAN card into the PC card slot on the rear panel of the projector.Important• The wireless LAN card must be inserted into the PC card slot in the correct direction. Itcannot be inserted in the reverse direction. If the card is inserted in the reverse directionwith excessive force applied, the pins in the projector and the PC card slot may break. Besure to insert the wireless LAN card with its label facing up.• Before touching the LAN card, touch a metallic object (such as a door knob or aluminumwindow frame) to discharge the static electricity from your body.• Always insert or remove the wireless LAN card when the main power is turned off. Failure to doso may cause projector malfunction or damage to the wireless LAN card. If the projector will notwork correctly, turn off the projector, wait 30 seconds, and turn it back on. Setting card in PC card slot1 Press POWER ON/STAND BY button to setthe projector to Stand-by mode, press the “O(off)” side of the main power switch of theprojector.2 With the label on the wireless LAN card facingup, slowly insert the card into the slothorizontally.NoteDo not apply any excessive force while inserting the card.ON/STAND BYSOURCEAUTO ADJUST3D REFORMSELECTON/STAND BYSOURCEAUTO ADJUST3D REFORM