NEC NP1200 User Manual

Also see for NP1200 Series: Control commands Command guide Command guide Supplementary guide Technical data sheet

Contents

NEC NP1200 User Manual Manual pdf 34 page image

233. Projecting an Image (Basic Operation) Selecting a SourceSelecting the computer or video sourceNOTE: Turn on the computer or video source equipment connected to the projector.Selecting from Source ListPress and quickly release the SOURCE button on the projector cabinet to dis-play the Source list. Each time the SOURCE button is pressed, the input sourcewill change as follows: “COMPUTER1”, “COMPUTER2”, “COMPUTER3”, “VID-EO”, “S-VIDEO”. To display the selected source, allow 1 second to elapse.Detecting the Signal AutomaticallyPress and hold the SOURCE button for a minimum of 2 seconds, the projectorwill search for the next available input source. Each time you press and hold theSOURCE button for a minimum of 2 seconds, the input source will change asfollows:COMPUTER1 → COMPUTER2 → COMPUTER3→ VIDEO → S-VIDEO →COMPUTER1 → ...TIP: If no input signal is present, the input will be skipped.Using the Remote ControlPress any one of the COMPUTER 1/2/3, VIDEO, and S-VIDEO buttons.Selecting Default SourceYou can set a source as the default source so that it will be displayed each timethe projector is turned on.1. Press the MENU button.The menu will be displayed.2. Press the  button twice to select [SETUP] and press the  button orthe ENTER button to select [GENERAL].3. Press the  button four times to select [OPTIONS(2)].4. Press the  button six times to select [DEFAULT SOURCE SELECT] andpress the ENTER button.The [DEFAULT SOURCE SELECT] screen will be displayed.(→ page 73)5. Select a source as the default source, and press the ENTER button.6. Press the EXIT button a few times to close the menu.7. Restart the projector.The source you selected in step 5 will be projected.TIP: When the projector is in Standby mode, applying a computer signal from a computerconnected to the COMPUTER 1 IN or COMPUTER 2 IN input will power on the projectorand simultaneously project the computer’s image.([AUTO POWER ON(COMP1/2)] → page 73)