599. AppendixNOTE 1: Pins 1, 4, 6 and 9 are no used.NOTE 2: Jumper “Request to Send” and “Clear to Send” together on both ends of the cable to simplify cable connection.NOTE 3: For long cable runs it is recommended to set communication speed within projector menus to 9600 bps.1 52 436 7 98To GND of PCTo RxD of PCTo TxD of PCTo RTS of PCTo CTS of PCPC Control Connector (D-SUB 9P)Cable ConnectionCommunication ProtocolBaud.rate........................................... .38400.bpsData.length........................................ 8.bitsParity................................................. No.parityStop.bit............................................. One.bitX.on/off............................................. NoneCommunications.procedure.............. Full.duplexNOTE: Depending on the equipment, a lower baud rate may be recommended for long cable runs.