NEC NP2200 Installation And Assembly Manual

Also see for NP1150 XGA: Control commands Manual Quick setup guide User manual Installation and assembly manual

Contents

NEC NP2200 Installation And Assembly Manual Manual pdf 9 page image

ISSUED: 06-16-09 SHEET #: 055-XXXX-1Visit the Peerless Web Site at www.peerlessmounts.com9 of 9For customer care call 1-800-729-0307 or 708-865-8870.Accessories listed in the included sheet, as well as other parts,can be ordered through Peerless by calling 1-800-729-0307 orvisiting www.peerlessmounts.com.Slide connection block with projector into projector mountassembly (A) as shown. Tighten captive screw to secureprojector to projector mount assembly (A).IMPORTANT: For security installations, insertone #10-32 x 1/4" socket pin screw (D) throughprojector mount assembly (A) and into connectionblock as shown.A CONNECTION BLOCKDCONNECTION BLOCKACAPTIVE SCREWFRONT OF MOUNT• Always use an assistant or mechanical lifting equipment to safely lift and position the projector mount.WARNING© 2006 Peerless Industries, Inc. All rights reserved.Peerless is a registered trademark of Peerless Industries.All other brand and product names are trademarks or registered trademarks of their respective owners.To adjust yaw (swivel) for threaded rod mounting applications: Loosen locknuts on threaded rods(step 5), until projector mount can be rotated. Rotate mount to desired position and retighten locknuts.To adjust yaw (swivel) for extension column applications: Loosen screw on projector mount assembly (A)indicated below until projector mount can be rotated. Rotate mount to desired position and retighten screw.To adjust pitch (forward and backward tilt): Turn knob on back of mount as shown below. Pull knob out andturn by hand for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.To adjust roll (side to side tilt): Turn knob on side of mount as shown below. Pull knob out and turn by handfor easy adjustment or insert #2 phillips screwdriver in end of knob and turn.Projector AlignmentSCREW FOR YAW (SWIVEL) STOP(REFER TO STEP 2, INSTALLATIONTO EXTENSION COLUMNS, FIG. 2.3)AKNOB FOR ROLLADJUSTMENTKNOB FOR PITCHADJUSTMENTBACK OF MOUNT10ACCESS SLOT FOROPEN END WRENCHALLOWS TIGHTENINGOF LOCKNUTSWITHOUT REMOVINGPROJECTORARROW INDICATESFRONT OF MOUNT8 9

/ 9

Related manuals for NEC NP1150 XGA