NEC NP30UCM Installation Manual

Contents

NEC NP30UCM Installation Manual Manual pdf 7 page image

Single Mounting Point InstallationMountingPointSecurityWrench1/4 - 20 x 5/16”Security ScrewIf your projector has only one mounting point, a ¼-20 x5/16” screw must be used to attach the mount to theprojector. Please refer to the following three steps:Step 1. Determine where the mounting point is located.Step 2. Place the projector plate over the mounting point.Step 3. Insert the ¼-20 x 5/16” security screw.This screw will use a standard hole when mounting.Ceiling Installation Solid Surface InstallationCeilingPlateConcrete WedgeAnchorUse a 1/8” drill bit to drill into the center of thestud before securing the supplied wood screws.The NOVA-EXT must be mounted to aceiling with a minimum 6” thickness. Useconcrete wedge anchors for concreteinstallation. A masonry bit must be used todrill the pilot hole.Step 1. Use two (2) #14 x 2” wood screws (supplied) to attachthe ceiling plate to a wooden ceiling stud.Step 1. Begin by placing the ceiling plate into position againstthe ceiling, keeping it level.Step 2. Mark off four holes to be used for securing the mountand place the ceiling plate aside.Step 3. Next, drill holes using the appropriate masonry bit foryour anchor.Step 4. Insert a concrete anchor into each hole.Step 5. If necessary, a hammer can be used to lightly tap eachanchor into place so that they are flush with the ceiling.Step 6. Once all of the anchors are in place, move the ceilingplate back into position.Step 7. Attach the nut onto the threaded shaft that is protrudingfrom the ceiling.Step 8. Do not tighten until all nuts are in place.Installation Manual Page - 7 -