373. Projecting an Image (Basic Operation)n Turning on the ProjectorOnce the projector is correctly located and the power cable and other connections are inplace, it is important that the projector is powered on correctly in order to avoid damage tocomponents and unnecessary wear and tear. Refer to the following guide to power on theprojector.1. Connect the power cable (A).Press the main power switch ( I )to the on position as shown (B).The power LED lights orange. BA2. Press the On/Standby buttononce (see 3 OSD Controls andStatus LEDS on page 8). Thepower LED lights green and theinternal cooling fan starts.3. After approximately 10 seconds,the power LED flashes intermit-tently green.4. The Lamp1 and Lamp2 LEDslight green and the Power LEDflashes more rapidly.5. Once the power LED is litsolidly green, the projector isready for use.Note:If any of the LEDs remain flashing or blink there may be a problem with the startup.Please refer to theo Troubleshooting section on page 112.
