342. Projecting an Image (Basic Operation)❼ Turning off the ProjectorTo turn off the projector:1. First, press the (POWER) button on the projectorcabinet or the POWER OFF button on the remote control.The [POWER OFF / ARE YOU SURE ?] message will ap-pear.2. Secondly, press the ENTER button or press the(POWER) or the POWER OFF button again.When the projector is in STANDBY MODE, the POWERindicator lights up orange.• Before the POWER indicator lights up orange, thebuzzer sound is released when [NOTIFICATION SET-TING] for [BUZZER] is ON.Power OnSteady green lightStandbySteady orenge lightPress twice3. After the projector enters the standby state, turn off the projector power switch ([1]), then the light powerswitch ([2]).The POWER indicator will go off and the main power will turn off.• While the POWER indicator is blinking green in short cycles, the power cannot be turned off.ONONOFFOFFLight power switchProjector power switch4. Return the administrator switch to the OFF position, then remove the administrator key.Administrator switchAdministrator key5. Turn off the AC power to the projector.
