NEC Univerge DT310 User Manual

Also see for Univerge SV8100: User guide User guide User guide Quick reference guide User guide

NEC Univerge DT310 User Manual Manual pdf 34 page image

28TRANSFERRING CALLSUsing Manual Dial –With a call in progress:1. Press the Transfer key.2. Dial the station number.3. Announce the call (optional).4. Replace the handset.Using Direct Station Selection (DSS) –With a call in progress:1. Press the Transfer key.2. Press the programmed DSS.3. Announce the call (optional).4. Replace the handset.Note 1: If the called station is busy, replace thehandset to initiate a camp-on. Unansweredcamp-on calls and unscreened transfers willrecall to the transferring station.Note 2: To return to the original party, press theflashing Line key or Conf key.Note 3: A Programmable Function Key may beassigned for DSS.Note 4: To transfer a call directly to a personal voicemailbox, dial 8 after dialing the stationnumber.CONFERENCE1. Establish an internal or external call.2. Press CONF Softkey or the Conference key3. Dial third party. If external, dial ‘0’ for an outsideline.4. When third party answers press ADD Softkey orConference Key5. Press BEGIN Softkey or Conference key again.6. A conference call is established.Note: If you cannot add additional parties to yourconference, you have exceeded the system’sConference limit.7. Repeat steps 1~3 above to add more parties.HOLD STA 123456782-13 WED 5:40PMInPg ExPg P/U ÈTALKING TO STA 123452-11 MON 10:56AMConfICM DIALCONFAnHd Dir