NEC V221W User Manual

Also see for V191W: Specifications Product dimensions Specifications

Contents

NEC V221W User Manual Manual pdf 16 page image

English-14TroubleshootingNo picture• The signal cable should be completely connected to the display card/computer.• The display card should be completely seated in its slot.• Check front power Switch and computer power switch should be in the ON position.• Check to make sure that a supported mode has been selected on the display card or system being used. (Pleaseconsult display card or system manual to change graphics mode.)• Check the monitor and your display card with respect to compatibility and recommended settings.• Check the signal cable connector for bent or pushed-in pins.• Check the signal input.Power Button does not respond• Unplug the power cord of the monitor from the AC outlet to turn off and reset the monitor.Image persistence• Image persistence is when a “ghost” of an image remains on the screen even after the monitor has been turned off.Unlike CRT monitors, LCD monitors’ image persistence is not permanent, but constant images being displayed for along period of time should be avoided.To alleviate image persistence, turn the monitor off for as long as an image was displayed. For example, if an imagewas on the monitor for one hour and a residual image remains, the monitor should be turned off for one hour to erasethe image.NOTE: As with all personal display devices, NEC DISPLAY SOLUTIONS recommends using a screen saver at regularintervals whenever the screen is idle or turning off the monitor when not in use.Image is unstable, unfocused or swimming is apparent• Signal cable should be completely attached to the computer.• Use the OSD Image Adjust controls to focus and adjust display by increasing or decreasing the fine total. When thedisplay mode is changed, the OSD Image Adjust settings may need to be re-adjusted.• Check the monitor and your display card with respect to compatibility and recommended signal timings.• If your text is garbled, change the video mode to non-interlace and use 60 Hz refresh rate.LED on monitor is not lit (no green or amber colour can be seen)• Power Switch should be in the ON position and power cord should be connected.Display image is not sized properly• Use the OSD Image Adjust controls to increase or decrease the H.SIZE.• Check to make sure that a supported mode has been selected on the display card or system being used.(Please consult display card or system manual to change graphics mode.)No Video• If no video is present on the screen, turn the Power button off and on again.• Make certain the computer is not in a power-saving mode (touch the keyboard or mouse).

/ 18

Related manuals for NEC V191W