213. Projecting an Image (Basic Operation)12Adjustable Tilt FootExhaustVentAdjust the Tilt Foot1. Lift the front edge of the projector.CAUTION:Do not try to touch the Exhaust Vent during Tilt Foot adjustment asit can become heated while the projector is turned on and after it isturned off.2. Rotate the Adjustable Tilt Foot on the front of the projector toextend the adjustable tilt foot.The tilt foot can be extended up to 0.7 inch/18 mm.There is approximately 5 degrees (up) of adjustment for the front ofthe projector.CAUTION:• Do not use the tilt-foot for purposes other than originally intended.Misuses such as using the tilt foot to carry or hang (from the wall orceiling) the projector can cause damage to the projector.Adjusting the left and right tilt of an image [Rear foot]1. Remove the spacer (black rubber) from the rear foot.Keep the spacer for future use.2. Rotate the rear foot.The rear foot can be extended up to 0.4 inch/10 mm, shorten by0.3inch/7mm. Rotating the rear foot allows the projector to be placedhorizontally.NOTE: After using the projector, attach the spacer to the rear foot.Spacer (blackrubber)Rear footUp Down
