NEC VE303 User Manual

Also see for VE303: Installation guide

Contents

NEC VE303 User Manual Manual pdf 22 page image

15... E n g l i s hIntroductionUsing the utility software “Virtual Remote Tool” that you candownload from our web site (http://www.nec-display.com/dl/en/index.html), Virtual Remote screen (or toolbar) can bedisplayed on your computer screen.This will help you perform operations such as projector’spower on or off and signal selection via the computer cable(VGA) or serial cable.ToolbarVirtual Remote screenThis section provides an outline of preparation for use ofVirtual Remote Tool.For information on how to use Virtual Remote Tool, see Helpof Virtual Remote Tool. Please refer to page 19.Step 1: Install Virtual Remote Tool on the computer. Pleaserefer to page 16.Step 2: Connect the projector to the computer. Please refer topage 17.Step 3: Start Virtual Remote Tool. Please refer to page 18.TIP:• Virtual Remote Tool can be used with a serial connection.• For update information on Virtual Remote Tool, visit our website:http://www.nec-display.com/dl/en/index.html• The projector’s COMPUTER IN connector supports DDC/CI (DisplayData Channel Command Interface). DDC/CI is a standard interface forbidirectional communication between display/projector and computer.Using the Computer Cable (VGA) toOperate the Projector (Virtual Remote Tool)Using the Downloadable Software When “ComputerIN”is selected forinput, the VirtualRemote screen orthe toolbar will bedisplayed as well asyour computer screen. Use the suppliedcomputer cable(VGA) to connectthe COMPUTER INconnector directlywith the monitoroutput connector ofthe computer to useVirtual Remote Tool.Using a switcher orother cables than thesupplied computercable (VGA) maycause failure in signalcommunication. VGAcable connector: PinNos. 12 and 15 arerequired for DDC/CI. Virtual RemoteTool may not workdepending onyour computer’sspecifications andversion of graphicadapters or drivers.