NEC Display Solutions of America, Inc.WT610E Installation GuideDesktop and Ceiling Mount v2.4www.necdisplay.com WT610E Page 9 of 9Input PanelMONITOR OUTCOMPUTERCOMPUTER INControl Codesl CodesFunction Code DataPOWER ON 02H 00H 00H 00H 00H 02HPOWER OFF 02H 01H 00H 00H 00H 03HINPUT SELECT RGB 02H 03H 00H 00H 02H 01H 01H 09HINPUT SELECT DVI (ANALOG) 02H 03H 00H 00H 02H 01H 02H 0AHINPUT SELECT DVI (DIGITAL) 02H 03H 00H 00H 02H 01H 1AH 22HINPUT SELECT VIDEO 02H 03H 00H 00H 02H 01H 06H 0EHINPUT SELECT S-VIDEO 02H 03H 00H 00H 02H 01H 0BH 13HINPUT SELECT VIEWER 02H 03H 00H 00H 02H 01H 1FH 27HPICTURE MUTE ON 02H 10H 00H 00H 00H 12HPICTURE MUTE OFF 02H 11H 00H 00H 00H 13HSOUND MUTE ON 02H 12H 00H 00H 00H 14HSOUND MUTE OFF 02H 13H 00H 00H 00H 15HON SCREEN MUTE ON 02H 14H 00H 00H 00H 16HON SCREEN MUTE OFF 02H 15H 00H 00H 00H 17HNote: Contact your NEC rep for codes not listed.Cable ConnectionCommunication Protocol: PC Control Connector (DIN-8P)Baud Rate: 38400 bps To RxD of PC12345678To TxD of PCTo GND of PCData Length: 8 bitsParity: No ParityStop Bit: One bitX on/off: NoneCommunications: Full duplexNOTE 1: It is recommended to set the projector to “Idle Mode” in the Setup menu for best Power ON response.NOTE 2: Pins 2, 3, 5, 6 and 8 are used inside the projector.NOTE 3: For long cable runs it is recommended to set communication speed in the Setup menu to 9600 bps.