Sometimes certain faults detected can be easilyresolved. Before calling the Technical AssistanceService, bear in mind the following advice:Faults14Fault Possible cause SolutionThe generalelectrical system ismalfunctioning.Defective fuse.The automatic safety switch hastripped or a fuse hasblown.Check the fuse in the mainfuse box and change it if it isdamaged.Check the main controlpanel to see if the automaticsafety switch has tripped ora fuse has blown.The automatic ONfunction does not work.There may be food or cleaningproducts stuck between theignition sparkers and theburners.The burners are wet.The burner covers are notcorrectly positioned.The appliance is either notearthed, not connected properlyor the earth connection is faulty.The space between the ignitionsparker and the burner mustbe clean.Dry the burner covers carefully.Check that the covers are correctlypositioned.Contact an electrical engineer.The burner flame is notuniform.The burner components are notcorrectly positioned.The grooves on the diffuser aredirty.Ensure the components arecorrectly positioned.Clean the grooves on the diffuser.The flow of gas doesnot appear normal or nogas comes out.The gas mains are turned off.If the gas is supplied from a gasbottle, check that this isnot empty.Turn on all stop cocks.Change the gas bottle.The kitchen smells ofgas.A gas tap has been left on.There may be a leak from thecoupling to the gas bottle.Turn off the gas taps.Check that the coupling issound.The safety valve on oneof the burners is notworking.The control knob was not helddown for long enough.The grooves on the diffuser aredirty.Once the burner is lit, holdthe control knob down a fewseconds longer. Clean thegrooves on the diffuser.