en Rinse aid16Switching off low saltindicator / water softeningsystemSwitchingoffwatersofteningsystem If the use of combined detergents with asalt component impairs the low saltindicator P on the control panel orthe text on the display window at thetop @ (enough salt for x rinse cycles),the displays can be switched off.Proceed as described under “Settingwater softening system” and set thevalue to 0-8. The water softening systemand salt refill indicator are now switchedoff., Rinse aidRinseaid As soon as the low rinse-aid indicatorH is lit on the control panel or isrequested on the front display * ):,rinse-aid should be topped up.The rinse aid is required for stain-freeutensils and clear glasses. Use onlyrinse aid for domestic dishwashers.Combined detergents with rinse-aidcomponent may be used up to a waterhardness of 21° dH (37° fH, 26°Clarke, 3.7 mmol/l) only. If the waterhardness is over 21° dH, rinse-aid mustbe used.* depending on the features of yourdishwasherTop up the rinse-aid as follows:1. Open dispenser 92; press lug onthe lid (1) and lift (2).2. Add rinse-aid up to the max. mark.3. Close the lid.Lid “clicks” into position.4. Remove overflowed rinse aid with acloth.This prevents excessive frothingduring the next rinse cycle.Setting amount of rinse aidThe amount of rinse aid to bedispensed can be set from 0 to 6. Setthe amount of rinse aid to be dispensedto 5 to obtain a very good drying result.Do not change the amount of rinse aidunless there are streaks or water stainson the utensils. Set a lower level toavoid streaks. Set a higher level toavoid water stains.PD[