NEFF T4..3.. Instruction Manual
Also see for T4...4 Series: Instruction manual
                                            | |
Contents
| 
28Care and cleaningThe advice and warnings contained in this section aim to guideyou in cleaning and maintaining the hob, so that it is kept in thebest possible conditionHobCleaningClean the hob after each use. This prevents food remains lefton the surface from burning. Wait until the hob is cold enoughbefore attempting to clean it.Only use cleaning products specifically designed for glass-ceramic hobs. Follow the instructions provided on thepackaging.Do not use:■ Abrasive products■ heavy-duty cleaners, like oven sprays and stain removers■ Pads that may scratch■ High-pressure or steam cleanersGlass scraperRemove dried-on food remains using a glass scraper.1. Release the scraper safety catch2. Use the blade to clean the hob surfaceDo not attempt to clean the hob surface with the base of thescraper. This could result in scratching.ã=Risk of injury!!The blade is extremely sharp. Risk of cuts. Protect the bladewhen not in use. Replace the blade immediately when anyimperfections are found.Care of the applianceApply an additive to protect and preserve the hob. Follow theadvice and warnings provided with the product.Hob frameIn order to avoid damage to the hob frame, follow theindications below:■ Use only slightly soapy hot water■ Do not use sharp or abrasive products■ Do not use a glass scraperThe Tipp controlFor cleaning the Tipp control, warm water and a little soap isrecommended. Do not use abrasive or corrosive cleaningproducts. Do not clean the Tipp control in a dishwasher or inwashing up water. Otherwise, it could be damaged.Fixing malfunctionsMalfunctions are generally caused by minor faults. Beforecontacting the Technical Assistance Service, ensure you haveread the following recommendations and warnings.Indicator Malfunction Measurenone The electric power supply has been cut off. Check other electrical appliances to check whether there has been apower cut.The appliance has not been properly con-nected following the connection diagram.Check that the appliance has been connected properly according tothe connection diagram.Electronic system malfunction. If the malfunction is not resolved by the above checks, contact theTechnical Assistance Service.“ flashing The control panel is wet or an object isresting on it.Dry the control panel area or remove the object.“§ + number /š + number /¡ + numberElectronic system malfunction. Disconnect the range from the mains. Wait about 30 seconds, thenconnect it again.*“§„‰ The Tipp control was dragged instead ofslanting it towards the required hotplateWait a few seconds, then switch on the range and hotplate properlyonce again.”‹ / ”Š There is an internal error in the system. Disconnect the range from the mains. Wait about 30 seconds, thenconnect it again.*”ƒ The electronic system has overheated andthe related hotplate has been switched off.Wait for the electronic system to cool down. Then push any symbolon the range.*”… The electronic system has overheated andall of the hotplates have been turned off.—‚ Incorrect voltage supply, outside the nor-mal operating limits.Please contact your local electricity company.—ƒ / —„ The hotplate has overheated and switchedoff to protect its working surface.Wait until the electronic system has cooled down sufficiently beforeswitching the hotplate back on.* If the indicator persists, call the Technical Assistance Service.Do not rest hot pans on the control panel. |
Related manuals for NEFF T4...4 Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine