5Your new appliancePage 2 shows an overall view of your new appliance as well asthe burner power.AccessoriesThe following accessories can be purchased from theTechnical Assistance Service:--------CodeThe manufacturer accepts no liability if these accessories arenot used or are used incorrectly.Gas burnersThere are indications to show which burner each control knoboperates.It is essential to ensure that all the burner parts and pansupports are correctly installed for the appliance to workcorrectly. Do not swap the burner caps around.Switching on manually1. Press the chosen burner control knob and turn itanticlockwise to the required setting.2. Use any type of lighter or flame (cigarette lighter, matches,etc.) and bring it close to the burner.Switching on automaticallyIf your hob can be switched on automatically (ignition sparkers):1. Press the chosen burner control knob and turn itanticlockwise to the maximum power setting.While the control knob is still pressed down, sparks areproduced on all burners. The flame ignites.2. Release the control knob.3. Turn the control knob to the required setting.If it does not come on, turn the control knob to the off settingand repeat the steps above. This time, press and hold thecontrol knob for longer (up to 10 seconds).Additional wok pan supportOnly for use on wok burnerswith pans with a round base.The additional wok pan sup-port should be used to pro-long the appliance's usefullife.Additional coffee maker sup-portOnly for use on the auxiliaryburner with pans which are nomore than 12 cm in diameter.Simmer PlateThis accessory has beendesigned to reduce the levelof heat at the lowest powersetting.Place the accessory directlyon the pan support with thecones facing upwards, neverdirectly over the burner. Cen-tre the pan over the acces-sory.Z2472X0 Additional wok pan support: cast iron (3.3 kW)Z2471X0 Additional wok pan support: cast iron (4 kW)Z2402X0 Additional coffee maker supportZ2480X0 Simmer Plate